Kentix KSS-BASIC-2-B Instrukcja Obsługi Pobierz pdf (Strona 35)



5.6. MultiSensor-Rack

The MultiSensor-RACK can be operated as stand alone device, but also in combination with an

AlarmManager-PRO. The AlarmManager then controls the environmental sensors.

For configuration in stand alone operation a web server is integrated, which allows you to control and setup

the device via LAN and a web browser.

Over the SNMP interface, an integration in network management systems is possible.

5.6.1. Safety note and installation

In case of a power failure, the settings are not lost. Energized relays drop out and go back when the power

returns to the unswitched, closed output state.

To bridge longer downtimes, use a suitable UPS system.

In case of an equipment failure an uninterruptible power supply to the connected devices is ensured by the

closed state of the relays.

To ensure the security and integrity of the operator and the correct operation of the KENTIX MultiSensor-

RACK, the execution of the installation only has to be done by an expert. Also ensure that the relevant

requirements are met.

Connection via PC: Connect the LAN jack from the MultiSensor-RACK over a LAN cable with your

network and your PC. Pay attention that you have to use a Cross-Over network

cable, by a direct connection.

Set the IP address of your PC to e.g. „192.168.100.123“.

5.6.2. Default settings

Voltage supply: Basic voltage supply realized with PDU-1 power input

Default IP-address: 192.168.100.223

Subnet mask: 255.255.255.0

Gateway: 192.168.100.1

User: admin

Password: password

Page  (04-2015, subject to change) kentix.com35

IMPORTANT! - Reset to factory defaults

If you have forgotten the IP-address or login information of the MultiSensor-RACK, you can reset the

device to factory defaults.#

To do this press both buttons for the display control at the same time and hold them down.#

After 10 seconds a security prompt is displayed. By pressing the right button the MultiSensor will then be

reset to factory defaults.

After this procedure the device will restart and can then be accessed via the default settings.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

Brak uwag

Kentix KSS-BASIC-2-B Instrukcja Obsługi Strona 35