Kentix MultiSensor-RACK Instrukcja Obsługi Pobierz pdf (Strona 48)

How to open the case of MultiSensor and AlarmManager

The device lids of the MultiSensor-RF/LAN or AlarmManager are jammed in one surrounding groove on the

device bottom part with the electronics. The lid can be lifted without tools by slightly pulling it apart on its

sides. Proceed as follow:

Open the device lid:

1. Lay down the device with the port side forward.

2. Pull the lid at the sides apart sightly (see picture).

3. The lid will snap out from the surrounding groove with a clicking noise.

4. Now, you can pull up the lid.

Close the device lid:

1. Lay down the device with the port side forward.

2. Pay attention, that the broader protrusion from the lid (space groove to casing edge) shows in the

direction of the connectors.

3. Pull the lid by the sides apart slightly and put the casing lid on the bottom part.

4. Slide the lid on the bottom part till the lid snaps in with a clicking sound.

ATTENTION!

The PIR motion sensor and temperature sensor in the MultiSensor-RF/LAN are fixed to the board of the

MultiSensor via a plug connector. It is important to open the lid with the motion sensor carefully to the left

side after pulling it down from the rabbet, to avoid harming the cabling or the connector.

Page 48 ! ! ! ! (08-2014, subject to change) kentix.de

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 70 71

Brak uwag

Kentix MultiSensor-RACK Instrukcja Obsługi Strona 48